Fisheye special features (OvrC)

Contents:

Adding Fisheye virtual streams to a Luma x20 NVR (OvrC)

Note: The Fisheye camera must be online and claimed in OvrC before additional streams are assigned. See Quick Start (Using OvrC).

The Fisheye camera has 4 additional streams that can be assigned to open channels on a Luma x20 NVR.

1. Select the NVR from the Device List.

2. Select the unassigned camera streams.

3. Click assign.

Pro Tip: OvrC does not currently specify the display mode associated with the default camera name.

Each Fisheye stream name can be set through the NVR's Channel Settings.

Fisheye Parameters

Caution: Set the stream mode and installation method via Config > Fisheye Parameters before viewing the live image.

Installation method:

  • Wall

  • Table

  • Ceiling

Warning: If your camera is wall mounted, ePTZ controls may not behave as expected. This will be resolved with a future firmware update.

Configure

Use this tab to configure the following:

  • IP settings

  • Time settings

  • Image settings

  • Audio settings

  • Scheduled reboot

  • On Screen Dislay settings

  • Video settings

  • Fisheye Parameters

  • SD Card settings

  • Camera credentials

  • Video Quality

  • Reset to Factory Default

See all fisheye special features here.